400-600mm (16-24″) i/d Pumice Liner
400mm to 600mm liners are for a grand open fire, inglenook or a feature chimney that needs a large flue.
Which large pumice liner do I need?
These are rebated volcanic pumice liners, sold as single lengths rather than a stove pack. Tell us the internal diameter and the height and we will list the liners, lip glue and LECA.
Specification (Isokern price list):
Light Expanded Clay Aggregate (50L Bag)
Insulation between the liners and the masonry, minimum 15mm.
View400mm to 600mm pumice flue liner specification
| Internal diameter | Nominal size | Outside diameter | Section length | Approx. weight |
|---|---|---|---|---|
| 400mm | 16″ | 470mm | 1000mm | 50kg |
| 450mm | 18″ | 530mm | 1000mm | 60kg |
| 500mm | 20″ | 590mm | 1000mm | 70kg |
| 600mm | 24″ | 706mm | 1000mm | 100kg |
Certified by Schiedel to EN 1857 (T600 N2 D 3 G). Suitable for all fuel types, but not for condensing appliances.
Installation points from Schiedel
- Install the liners socket uppermost and seal every joint with Isokern lip glue, about 2mm thick, removing any excess.
- Surround the liners with at least 100mm of brick, block or stone, with a minimum 15mm of LECA mixed 20:1 with OPC cement in between.
- Support any bends and backfill them with the LECA mix.
- Keep combustible materials 200mm from the inner surface of the liner, or 40mm from the outside of the masonry chimney.
- Terminate the chimney at the correct height under Approved Document J, then test it and fix the chimney notice plate in the dwelling.
The flue size is set by the appliance, so always follow the stove or fire manufacturer's instructions and Approved Document J.
These sizes are sold as single liners rather than packs. Use the liner calculator or contact us with the internal diameter and chimney height for a parts list.
Compare every size on the pumice flue liners page, or read how Isokern pumice flue liners work.
Large pumice liner FAQs
Can I use a smaller liner than the stove outlet?
No. Schiedel states the pumice flue must not be smaller than the spigot diameter of the appliance. The flue size is set by the appliance manufacturer.
How tall must the chimney be for an open fire?
Schiedel gives a minimum chimney height of 4.5m from the top of the fire opening. Large open fires need a correctly sized flue, so check the fireplace opening against Approved Document J.
Can a large pumice flue serve a condensing appliance?
No. Schiedel states pumice is suitable only for dry chimneys, so it cannot be used with condensing appliances, including pellet and biomass.
Do I need a chimney pot?
Not necessarily. Schiedel says a pot or terminal is not essential, but it can be fitted for appearance or to help keep rain and birds out. The chimney can be finished by flaunching around the liner itself.
How are large pumice flues swept?
At least twice a year, before and after the heating season, with a medium-density polypropylene brush the same diameter as the flue. Steel brushes must not be used on pumice flues.
Need help choosing your large pumice liner?
Speak to our Isokern team on 0113 322 5187 or email [email protected]. We can check sizes, flue requirements and what to order.
Isokern is made by Schiedel; we are not the manufacturer.


Pallet




